Abdul Amiet asked 1 สัปดาห์ ago
Duty cycle is one of the most misunderstood figures on a welder’s spec sheet, yet it tells you more about real-world usability than the headline amperage does. It’s expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn’t flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.
Getting the right disc for the material and finish you’re after saves both abrasives and time, and it’s worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as https://harry.main.jp/mediawiki/index.php/TIG_Welding_Consumables:_Tungsten,_Collets_And_Gas_Lenses_Explained.
The abrasive material itself matters as much as the shape. Discs formulated for steel typically contain aluminium oxide, while stainless steel usually calls for an inox-rated disc that’s free from iron, sulphur and chlorine contaminants that could otherwise cause surface corrosion on the stainless. Aluminium and other soft, non-ferrous metals need their own dedicated abrasives too, since standard steel discs tend to clog quickly and produce a poor finish on softer materials.
Buying a first welder is easy to overthink. Rather than starting from a shortlist of machines, it helps to start from the work: what materials, what thickness, and how much of it will be done indoors versus outside or on-site. That single question narrows the choice between MIG, TIG and MMA far more usefully than comparing spec sheets in isolation, whether you end up looking at a Jasic entry-level MIG package or something further up the range.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.