Jason O'Reilly asked 1 เดือน ago
Specifying a fill valve replacement sounds like a simple job until the plumber gets to site and finds the water supply enters the cistern from an unexpected direction. Fill valves are built around one of two entry positions, side-entry or bottom-entry, and the wrong choice means either a valve that will not connect to the existing pipework or one that fouls the cistern wall on the way in.
Before ordering, check where the existing supply pipe meets the cistern and measure the available depth if the tank is compact. Plumb2U stocks both side-entry and bottom-entry fill valves, including combination types that cover both configurations from one body, at trade prices for plumbers who need to match the part to the pipework rather than the other way round. Plumb2U’s range, backed by next-day despatch on the common models, makes it straightforward to specify the correct entry position before the part goes in the van.
Read more from http://www.plumb2u.com.
Start with the fill valve. This is the mechanism that lets water into the cistern after a flush and shuts off once the tank reaches the correct level, usually via a float or a diaphragm. When a fill valve wears, the most common signs are a hissing or trickling noise that continues long after the cistern should have stopped filling, a water level creeping up to or past the overflow pipe, or a float arm that no longer rises high enough to trigger shut-off. Mineral deposits inside the valve seat are often the culprit, particularly in hard water areas, and once the seal degrades a full replacement is usually more reliable than trying to clean it out.
A dual-flush button looks simple from the top of the cistern lid, but underneath it is doing a more complicated job than a single-flush handle ever had to. Pressing one half of the button needs to trigger a short flush, while the other half needs to lift the flush valve fully for a complete cycle, and the mechanism that makes this happen is usually either a rigid spindle or a flexible cable running down to the flush valve itself.
A flush valve, by contrast, works as a straightforward seal at the base of the cistern that lifts to let water fall directly through into the pan under gravity, with no siphoning action involved, and shuts again once the float or timer mechanism allows it to reseat. Flush valves are what almost all dual-flush cisterns use, since a siphon’s all-or-nothing action makes a genuine short flush difficult to achieve, whereas a valve can simply be held open for a shorter or longer period.